Roll-On

 

   F.A.Qs.

[ Up ] [ Products ] [ FireFly Luminosity ] [ Instructions ] [ F.A.Qs. ] [ Suggestions ] [ Contact Me ] [ What's New ]

 

This page contains answers to common questions handled by our support staff, along with some tips and tricks that we have found useful and presented here as questions.

 

  1. What is a Roll-On Skate Floor System?
  2. Where can I find a Roll-On skating floor?
  3. How much does it cost for a Roll-On Skate Floor System?
  4. How often do you have to re-coat the skating floor?
  5. How much does it cost to re-coat a Roll-On skating surface?
  6. Any helpful hints before I get started?

What is a Roll-On Skate Floor System?

A Roll-On Floor System is a liquid coating system that may be applied to asphalt, concrete, high density particle board or hardwood floors.

Back to Top

Where can I find a Roll-On skating floor ?

Roll-On is the most popular selling skate floor finish in the United States and is used by most traditional skating rinks and better roller hockey facilities.  We suggest you check your local telephone directory to find the roller skating center nearest you.   They are more than likely using Roll-On Skate Floor Finish or a Roll-On skate floor system.

Back to Top

How much does it cost for a Roll-On Skate Floor System?

The final cost of a Roll-On Skate Floor System depends on the type of base (floor) that will be coated.  In general, your square foot cost EXCLUDING labor for coating a Roll-On Skate Floor System over an existing base (floor) will be:

Bare concrete (basic system)   .25 per square foot
Bare concrete (premium system)   .42 per square foot
Bare hardwood   .29 per square foot
Bare high-density particle board   .69 per square foot
Bare asphalt 1.16 per square foot
Back to Top

How often do you have to re-coat the skating floor?

How often you re-coat your surface depends on the amount of skating traffic you have.   The average skating center will re-coat one coat of Roll-On Skate Floor Finish per year.

Back to Top

How much does it cost to re-coat a Roll-On skating surface?

Bare concrete (basic system) .07 per square foot
Bare concrete (premium system) .07 per square foot
Bare hardwood .07 per square foot
Bare high-density particle board .07 per square foot
Bare asphalt .07 per square foot
Back to Top

Any helpful hints before I get started?

When prepared and applied correctly, Roll-On will provide you with the best skating surface available.  The following "tips" should help:

-    Always follow directions carefully.

-    Always sand your floor between coats.

-    DO NOT coat too thick.  A thick coat will not allow your coating to dry properly and could cause your surface to wrinkle or peel.

Back to Top
 

                    WB00941_.GIF (1211 bytes)                                            
Roll-On is a trademark of Nazzaro Enterprises, Inc. All other products mentioned are registered trademarks or trademarks of their respective companies.

Questions or problems regarding this web site should be directed to sherry@roll-on.com.
Copyright © 1997 Nazzaro Enterprises, Inc. All rights reserved.
Last modified: Thursday May 06, 1999.