|
|
Before You BeginSuper Base Two-Part Epoxy was designed as a base coating to be used to smooth asphalt, concrete and particle board surfaces and is not intended to be used as a skate floor coating. Roll-On Skate Floor Finish over Super Base insures the best possible skating surface. Storage
Preparation- NOTE: Shut down all sources of flame around the area where Super Base is to be used. Do not mix or apply near open flame or operating sparking system. When mixing Super Base, it is not necessary to use an electric mixer. 1. Before combining Part A and Part B, stir each part with a mixing paddle for a minimum of 5 minutes or until all solids are thoroughly mixed. 2. Pour equal amounts of Part A and Part B into a 20 gallon (or larger) GALVANIZED trash container. DO NOT USE RUBBER TRASH CONTAINERS. Maximum amount to be mixed -- 10 gallons per container. 3. Stir mixture with a mixing paddle for a minimum of 5 minutes per container or until completely blended. 4. Allow mixture to cure in the 20 gallon container for 45 MINUTES before applying. Once mixed, Super Base has a maximum pot life (the useful liquid life of the epoxy after it has been mixed) of 4 hours at 68 to 72 degrees (F). For mixing smaller quantities of Super Base, please call 1-800-227-8931. 5. During the 45 minute curing time, stir mixture briefly every 10 minutes.
|
|
|
